Description

8.9″4K Mono Screen Conversion Kit

The 8.9″4K Mono Screen is compatible with the EPAX X10 3D printers. The mounting bracket and new mainboard are required for existing X10 printers to use this screen.

Features

• Monochrome LCD screens last much longer than color screens (with proper use the screen should last several thousand hours)
• This screen has tempered glass installed on top. So even if you spill resin on top of it you can gently shovel it off without damaging the screen
• Very short layer exposure times are needed (up to 1/4th of the time needed for color LCD screens)

Specifications of LCD

• Monochrome LCD in size 8.9″ diagonal
• Resolution: 3840*2160
• Pixel precision: about 47um

Inside the box

• 1* 8.9″4K Monochrome LCD Screen
• 1* Mounting bracket
• 1* New mainboard supporting 4K Mono Screen
• 1* Touch Screen Cable

Information

• Do not leak resin under the screen through edges
• Cover edges with 0.1mm thick Kapton tape or reinforced electric tape
• A lot of failed screens are due to tiny residues in the resin vat between prints. The residues get pushed into the screen by the build platform, leading to heated stress spots and sometimes even cracks in the screen
• Some failures are also due to unnecessary overexposure time settings
• Because screens are considered consumables they are NOT covered by a warranty

Note

• ALWAYS make sure your vat NO any residues and that the build plate has nothing on it before starting a new print job.  Monochrome screens are more expensive due to being produced in smaller volumes only for 3D printing.
• Using this screen with other similar 3D printers is NOT supported
• Replacing your screen always involved re-leveling your build plate

Support

• Quick guide for an upgrade from X10 10.1″ 2K color to X10 8.9″ 4K mono