1: Check resin vat FEP before first use. Place resin vat on some kitchen paper and fill with water. Wait for a few hours and check for water on the kitchen paper. If the kitchen paper is dry, remove water from resin vat and dry it carefully
2: Check LCD projection before printing / dry run
3: Make sure your resin settings are correct
4: Level your buildplate carefully
5: Sand your buildplate when sandpaper when it was supplide with your printer
6: Do not overfill resin vat (about half full)
7: Minimum room temperature for printing depending resin but always >21C
8: Shake resin well before use
9: Do not use metal scraper on your FEP film
10: Remove resin vat from printer when you need to remove a failed print from the resin vat.
11: Make sure your sliced layer height matches the printer set layer height