Description
High quality, high airflow replacement fan for Wanhao D7 and other 3D printers. Moves much more air then the regular o.18A fan. The Dual Ball Bearing construction makes it much more reliable . Especially for UV LED Cooling since the sleave bearing fans as used by Wanhao are not designed to operate horizontal.
Specifications
- Type: 6010
- Brand: AVC
- Made in: Taiwan
- Dimensions: 60mmx60mmx10mm
- Rated Voltage: DC 12V
- Power: 0.4A
- Wire length: ~20cm
- Bearing Type: Dual Ball
- Connector: Motherboard 3-pin
- Blade Material: Plastic
Note 1: How to use this on the Wanhao D7 and most other 3D Printers
- Cut all wires except red (+) and black (-) from the fan
- Remove connector from the fan
- Strip the end of the wires bare
- Connect to printer control board, make sure to check polarity
Note 2: If you find the wire is too short
- You can use the red and black wires from the old fan
- Remove connector (and unused wires) from the new fan
- Connect the wires black on black, red on red
- Solder or use a luster terminal to permanently secure the old wires to the wires of the new fan
- Make sure you use isolation tape on any bare wires/connections
Reviews
There are no reviews yet.